The Turbo-wash replaces the pre-washing tank of the first-generation washing plants. The machine is designed according to the principles of a Vertical centrifuge and includes a combination of washing and a subsequent initial drying action. It is therefore possible to process very dirty pre-shredded material with high paper content and Aluminum foil residues. The Turbo-wash also improves the recovery rate of the Sink Float Tank.

The friction washer is made of a cylindrical trough with an inclined high speed running paddle screw to dewater and clean ground material (film flakes, granules and similar material).

The screw is fixed in the bearing housing by the means of two bearings and enclosed by a stainless steel screen.
The ground material and water are fed from above at the lower end of the trough.
Then the material is washed while being transported to the outlet at the top of the trough.
Fines and water are thrown through the fine screen to the outside while the friction of the high-speed screw cleans the material.
The drain is located at the lower end of the trough.
The screen is automatically cleaned by means of a water-rinsing unit.

Sink-float tank is used for floating material like film/lables like LDPE/HDPE/PP etc on the top and at the bottom all the sink material ilke PVC/PET/PC etc. both have different Discharge point to collect different material, based on density. It is mfg. as per application and size/capacity kg/hr.

Panchal provides an ideal choice of granulators for recycling plastic waste from Film, Tape, blow molding & Injection moulded waste. Grinder can be supplied with Wet & Dry both model Wet Grinder give better cutting, less fines generation and long life blade interval.

Special Design Features:-
-Mainly used for the washing of plastic film & plastic flake after shredded.
-The dirty material or sands will be removed by the centrifugal force producing by the high-speed rotating of the main shaft.
-The blades in the main shaft use anti-wearing steel & can be changeable.
-Seperate Bearing block from Water contact
-Dynamic balance rotor for sturdy run.

Sink-float tank is used for floating material like film/lables like LDPE/HDPE/PP etc on the top and at the bottom all the sink material ilke PVC/PET/PC etc. both have different Discharge point to collect different material, based on density. It is mfg. as per application and size/capacity kg/hr.

Centrifugal Dryer (Vertical type) is an Centrifuge which remove surface water from Soft to Rigid material.
Input Moisture 25%
Output Moisture 2-3% Rigid material like HDPE/PS/ABS/PET Flakes Soft material like LDPE/HDPE/PP Film.
For a gentle drying of the plastic flakes & virgin granule like PE, PA, PP, PS with simultaneous separation of impurities and fines